I have 18 pink tip injectors I cleaned and flowed and quite a range of difference about ten percent for some of the most extreme. I can put 6 identical
Last Post By: PanRonnie Today, 02:04 PMRecently serviced by Tommy Dunn. Replaced anything that needed attention. Will post pics this weekend. $2,100 plus shipping.
Last Post By: 25two.stroke Today, 01:47 PMI laugh every time I see this.
four pairs of three blade 15" x 28 30,32,34, and pitch
Last Post By: rashad-tci Today, 01:31 PMSportmaster 2.5 1.87 it’s 15” it ran perfect when last used it’s been sitting for 2 years 2200.00
Last Post By: rjdubiel Today, 01:30 PMTry to figure out why my 200hp merc is overheating, This is the second powerhead and both seem to do the same thing, I got a better run today with the
Last Post By: Aaronhl Today, 11:19 AMWhat are the pros and cons of foam decking, like SeaDek, for a performance river boat? Is it heavier than carpet?
Thanks in advance.
Seen a lot of old boat racers talk about boat racing......Lilabner got me thinking in one of his other posts. What about pictures the females back in
Last Post By: doug7488 Today, 06:18 AMhttps://www.gerrmarine.com/Articles/SeaSleds.pdf
https://youtu.be/HHYa4LudERQ
https://youtu.be/Uc90ZT_bY1M?si=O5d57rCCXkac3B3-
SOLD. SOLD I got this motor on a boat I bought. Boat is sold. Looking to sell the motor. It's a 225 Promax with very low hours. Factory remanufactured
Last Post By: KIRCHNER Today, 02:25 AMShort version- Melted #4 piston, swapped powerheads, trying to melt #4 in the new one too.
Long version -
After finally getting
Powerhead is a 2008 200XS SST Gen 2 with approximately 100 hours on it. Will get accurate reading from DDT. Has Mad EFI billet intake velocity stack,
Last Post By: Onetime Yesterday, 09:34 PMA sad state of affairs; regarding a deliberate callous and pompous disregard for upkeeping the beauty of nature.
This act and acts like this are
2011 stv euroski (full throttle)
pristine condition
orginal 2.5l efi 280 ros never been rebuilt very low original hours
ecu tunned
New member with a great project boat
Thread Starter: finneusjNew member here from McHenry, IL thanks for the add!
Last Post By: JBS Today, 02:26 PMI just picked up my first pleasure boat (I currently have a little aluminum row/tiller