18 ft Stratos fish and ski. Hull weighs 1400 lbs. I put a 90 hp Johnson on it. Going to used for pulling grandkids on tubes. I'm guessing around 19
Last Post By: bullet123 Today, 10:30 AMIs there anything available now for a 2018 Mercury 400R 2.6L SC which will increase the power besides buying a new 500R - 4.6L SC ?
When it was
Post a random photo thread! Add yours!
Post a random pic Thread i will Start Freeze Frame
Add yours
other forum has one of these
I've rescued a 1957 Johnson 18 HP from outdoor storage yard after sitting outside for 16 years. Problem is the mid section swivel pin is nearly frozen.
Last Post By: WaterZebra Today, 09:37 AMDoes anyone have any insight modifications that can be done to these engines other than a prop? Like carbs, exhaust, ignition block porting etc.)
Last Post By: David Today, 09:11 AMlifted from Facebook
"We got out boating this long weekend with the TUFF20 with Yamaha 150 SHO. First impressions of the little motor
I laugh every time I see this.
Recently serviced by Tommy Dunn. Replaced anything that needed attention. Will post pics this weekend. $2,100 plus shipping.
Last Post By: DangerNewb Today, 07:42 AMI need a bigger prop for my Checkmate. 1989 17' Spectra 2.5 200 HP. Propshaft level with the pad. I want a prop with lots of bow lift and no stern lift.
Last Post By: rjdubiel Today, 07:13 AMhttps://youtu.be/4Olk5AU_tfg?t=296
Last Post By: doug7488 Today, 06:09 AMI dont mess with omc very much. Where do you hook water psi tubing to? I read that you are supposed to put a "T" fitting into the tell tale
Last Post By: bullet123 Today, 05:20 AMCombustion Engines versus the ...political environment.
Hi,
I have a new to me 1990 Yamaha 115 2-stroke carb motor. It idles fine and runs good up to about 2200 rpm, then starts bucking and jerking.
Hi,
Bought an Exocet 23 (piranha hull with phantom deck) and I put a 300 R, 1.75 TM, on it (not an SM, no hydraulic jackplate on it).
electric catamaran boat to set world record
Thread Starter: noli.
Last Post By: noli Today, 10:30 AMRey Marino (may he rest in peace) would be very proud right about now to see his work become a world record holder