lifted from Facebook
"We got out boating this long weekend with the TUFF20 with Yamaha 150 SHO. First impressions of the little motor
I laugh every time I see this.
https://youtu.be/4Olk5AU_tfg?t=296
Last Post By: doug7488 Today, 06:09 AMI dont mess with omc very much. Where do you hook water psi tubing to? I read that you are supposed to put a "T" fitting into the tell tale
Last Post By: bullet123 Today, 05:20 AMCombustion Engines versus the ...political environment.
Hi,
I have a new to me 1990 Yamaha 115 2-stroke carb motor. It idles fine and runs good up to about 2200 rpm, then starts bucking and jerking.
Does anyone have any insight modifications that can be done to these engines other than a prop? Like carbs, exhaust, ignition block porting etc.)
Last Post By: OnPad Yesterday, 11:49 PMHi,
Bought an Exocet 23 (piranha hull with phantom deck) and I put a 300 R, 1.75 TM, on it (not an SM, no hydraulic jackplate on it).
Try to figure out why my 200hp merc is overheating, This is the second powerhead and both seem to do the same thing, I got a better run today with the
Last Post By: Tagg Yesterday, 07:40 PM.
Pantera building a plug from an original 24 footer
.
Rey Marino (may he rest in peace) would be very proud right about now to see his work become a world record holder
SOLD
1995 Summerford Stv Euro mod vp bottom
Low hour jsre 280
Diamond flashed ecu, 9000 rpm limit
20” offshore Mid
Hey Everybody,
I Made a Custom Set of Scream and Fly 260 Coil covers for Greg a little while back and decided I wanted to offer them
I have a complete setup to swap you 225 carb or EFI 3 liter to a 250. Complete intake VST, injectors, rails, wiring harness, computers, etc.
Surface running props
Thread Starter: skialot2I need a bigger prop for my Checkmate. 1989 17' Spectra 2.5 200 HP. Propshaft level with the pad. I want a prop with lots of bow lift and no stern lift.
Last Post By: rjdubiel Today, 07:13 AM